Skip to content
Brooklyn, NY Brooklyn, NY Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (929) 531-5990

Chimney Liner Installation in Mapleton, Brooklyn

Serving Mapleton and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (929) 531-5990

The short answer

Mapleton homes usually need a new chimney liner when the old clay tile flue is cracked or deteriorated, or when a boiler or water heater is switched from oil to gas. Our certified technicians inspect the flue first, size a liner to the appliance it serves, and install it so exhaust vents safely through the chimney.

A chimney liner is the protective channel inside your flue. It carries smoke and exhaust gases out of the house and keeps heat and corrosive byproducts away from the surrounding brick and wood framing. In Mapleton, many homes still rely on older masonry chimneys that were built for oil or coal but now vent gas boilers, water heaters or fireplaces. When the original clay tiles crack, or when the heating system changes, a new liner is often the safest and most practical fix. EliteSweep Chimney Services installs chimney liners for homes and small buildings in Mapleton's 11204 and 11230 ZIP codes, about two miles west of our office in Madison.

Why Mapleton Chimneys Often Need New Liners

Mapleton's housing is a mix of attached and semi-attached rowhouses, detached homes and smaller pre-war apartment buildings. Most of them have brick chimneys lined with clay tile, and some older flues have no real liner at all. Decades of heating seasons, freeze-thaw cycles and normal building settlement can crack tiles and wear away the mortar joints between them.

A damaged liner can let heat reach nearby wood framing, allow exhaust to leak into living spaces, or send carbon monoxide back into the house instead of up and out. Because the flue is hidden inside the chimney, these problems are easy to miss until an inspection finds them.

  • Pieces of tile or crumbled mortar at the base of the chimney or in the boiler cleanout
  • Water stains, white crusty deposits or peeling paint on walls next to the chimney
  • Rust on the boiler or water heater vent connector
  • A heating contractor or inspector telling you the flue is the wrong size for your appliance
  • A switch from oil heat to gas, or a newly installed appliance

Converting from Oil to Gas in Mapleton

Many Mapleton homeowners are replacing old oil boilers with gas equipment. When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the work. A new liner is often needed because gas exhaust produces acidic condensate that can corrode a masonry flue over time.

If you are planning a conversion, it helps to bring us in early. We can inspect the chimney, confirm whether it needs relining, and coordinate timing with your heating contractor so the new appliance is not left waiting on the flue.

How We Install a Chimney Liner

Every job starts with an inspection. The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year and recommends a Level 2 inspection when the system changes, such as a new appliance or a switch of fuel. That usually includes a camera inspection of the full length of the flue.

From there, we choose a liner sized to the appliance it will serve. Stainless steel liners are the most common choice for gas and oil boilers, water heaters and many fireplaces, because they resist corrosion and can be run down an existing flue without major demolition.

  • Inspect the chimney and flue, including a camera scan
  • Measure the flue and confirm the size required by the connected appliance
  • Clean the flue and remove loose or broken tile where needed
  • Lower the new liner from the roof and connect it at the base
  • Install a top plate and rain cap to keep out water and animals
  • Test the draft and review the finished work with you

Planning Around Heat Season

New York City's heat season runs from October 1 through May 31. During those months, building owners must keep apartments heated to the city's minimum temperatures, so a boiler that cannot vent safely is a serious problem for landlords and owners of multi-family homes. Late spring and summer are the easiest times to schedule relining, when shutting down the heating system for a day causes the least disruption.

If your chimney fails an inspection during the heating season, call us as soon as you can so we can discuss next steps and how to keep your household or tenants safe in the meantime.

Serving Mapleton and Nearby Neighborhoods

Our office in Madison is a short drive from Mapleton, so scheduling inspections and follow-up visits is straightforward. We also install chimney liners in Midwood, Homecrest, Gravesend, Madison and Flatlands, where many homes share the same older masonry chimneys and oil-to-gas conversion questions.

More services in Mapleton

Related

What to expect

How a visit goes

  1. We look before we recommend

    We inspect the flue, damper, crown, cap and connections first, then tell you what we found. Recommendations come from what is in your chimney, not from a standard package.

  2. We keep your home clean

    Drop cloths go down before any work starts, and soot and debris are contained and carried out. We leave the room the way we found it.

  3. We explain it in plain English

    You will hear what each problem is, why it matters, and what happens if you wait. If something can safely be left for later, we say so.

FAQ

Common questions

Don’t see your question? Call (929) 531-5990 and we’ll talk it through.

How do I know if my Mapleton chimney needs a new liner?

The only reliable way is an inspection, usually with a camera. Common signs include broken tile at the chimney base, water stains near the chimney, rust on the vent connector, or a recent change in heating equipment.

Do I need a new liner if I switch from oil to gas?

Often, yes. In New York City the chimney must be evaluated during an oil-to-gas boiler conversion, and gas exhaust produces acidic condensate that can damage an older masonry flue. Many conversions require a properly sized new liner.

What type of liner do you install?

Stainless steel liners are the most common choice for boilers, water heaters and many fireplaces. We size the liner to the appliance it serves after inspecting the flue.

How long does chimney liner installation take?

Many standard relining jobs are completed in a day. Chimneys that need tile removal, masonry repair or extra work at the roof may take longer, and we will explain the timeline after the inspection.

Will my heat be off during the installation?

The connected boiler or water heater is usually shut down while we work on the flue. That is why we recommend scheduling relining outside the October through May heat season when possible.

Do you install liners in apartment buildings as well as houses?

Yes. We work on chimneys serving rowhouses, detached homes and smaller pre-war apartment buildings in Mapleton and nearby Brooklyn neighborhoods.

Schedule a chimney or vent inspection

Tell us what you are noticing, whether it is smoke, smells, leaks or a slow dryer. We will inspect, show you photos, and give you a written price before any work begins.

Call (929) 531-5990 Request Service